Subject:
|
2 questions on Polaroid 6500
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 3 Jan 2002 12:02:29 GMT
|
Viewed:
|
1958 times
|
| |
|
|
Hi,
I bought a Polaroid 6500 for x-mas and now I’ve got two questions:
1) In the Handy Board Interfacing Diagram of the Polaroid 6500 at the
Handyboard page V+ is connected to the pin 9 of the Polaroid 9-pin
connector. But the flat cable to the pin 9 is black colored there. Shall
this mark V+? Aren’t black markings used to mark GND?
2) Can I run the Polaroid 6500 without the 0.1 µF capacitor in the C7
position on the sonar?
Are there any disadvantages if I do so?
Best regards,
Jan
|
|
Message has 1 Reply:
 | | Re: 2 questions on Polaroid 6500
|
| Jan, On ribon cable the lead that has the marking is simply there to make it easier to tell what lead is what on the other end. The marked lead usually denotes pin one, but not always. Remember that the drawing is show from a bottom view. Pin 9 is + (...) (23 years ago, 3-Jan-02, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
