Subject:
|
My handyboard does not run.....
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 21 Feb 1996 03:51:20 GMT
|
Original-From:
|
Kazuyoshi Inoue <kinoue@ai.mit*SayNoToSpam*.edu>
|
Viewed:
|
2063 times
|
| |
|
|
Dear Master of HB,
I bought a handy board made by Gleason Research (complete set), and
connect RS232C cable to my PC. After I put the board into download mode,
I put the command "a:> dlm pcode_hb." However, I found the following
message on the screen and I could not see anything but blank characters
on the LCD of the board.
I'd really appreciate if you let me know how to debug and fix this
problem.
Best regards,
Kazuyoshi Inoue
************** messges **************
Downloading eeprom loader to RAM at 1200baud.....
.....
.....
-----
512 total bytes (boot loader done)
Synchronizing with board...ok
Sending pcode_hb.s19 at 9600 baud
Board memory error: wanted 00, got 3e at address 8000
Board synchronization error.
|
|
Message has 1 Reply:
 | | Re: My handyboard does not run.....
|
| dlm is apparently having trouble. you've got the right COM port because it's able to get through the first phase of the download (the dots and dashes bootstrap). someone else had problems using dlm on a pentium. it's an aging dos program and i (...) (29 years ago, 21-Feb-96, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
