 | | 6.8 nF Capacitor —John Hatton
|
| | | Can any body tell me if a 6.6nF capacitor will do to replace the 6.8nF in the IR Transmission circuit (Fred?) ?. Thanks in advance. John Hatton (24 years ago, 6-Jul-00, to lugnet.robotics.handyboard)
|
| | | |
| | | | | Re: 6.8 nF Capacitor —Tom Napolitano
|
| | | | (...) Yes. Capacitors have typically very loose tolerances anyhow; usually 20% unless you buy specifically selected samples in a tighter tolerance. The 6.8 is a standard value while the 6.6 you have is likely a specially selected non-standard value. (...) (24 years ago, 6-Jul-00, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: 6.8 nF Capacitor —John Hatton
|
| | | | The 6.6nF was the capacitance measured for the two 6.8nF capacitors that I have managed to get (rated as 10% tolerance). The problem is that the parts listed for the HB are 2% tolerance 6.8nF capacitors which gives a lowest value of 6.6664nF which (...) (24 years ago, 6-Jul-00, to lugnet.robotics.handyboard)
|
| | | | |
