| |
I have recently obtain a handyboard kit.
This is my first board.
After connecting the Ni-Cad batteries and adapter, I proceeded to download
therequired .s19 file using HBDL.
It was unsuccessful.
The LCD screen displayed one line of brightly lighted squares.
I checked the LCD +5V supply, it was alright. What could be wrong?
I suspect that my battery connection may have some problems, how should I
check if my batterie are sound could they be shorted. tested one of the ,
voltage was okay but the current reads 6A. Is my multimeter not working?
I am using the recommended 1.2V 600mA bettaries
The RED LEDs for the motor O/P also lightes up when I tried to go into
bootstrap. The Red and Green LEDs no lightup for 1/3 sec and go off during the
process.
I would really appreciate any help/guidence
Thanks in advance,
Raymond
|
|
Message has 1 Reply:
 | | Re: Unable to go into bootstrap
|
| This problem is very common. Probably, your board is fine. Check this page on the Handyboard site to start off with : (URL) you have no luck with that, then try fooling with your port settings. Switch from xon-xoff to none, etc. Somewhere in there (...) (24 years ago, 29-Jun-00, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
