Subject:
|
Re: Adapting the LMD18200
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 30 Sep 1996 14:30:13 GMT
|
Original-From:
|
Tom G. Brusehaver/Consultant Euler Solutions <tgb@bnu003.cncc#stopspammers#.bnr.com>
|
Reply-To:
|
[tgb@bnr]stopspam[.com]
|
Viewed:
|
1479 times
|
| |
|
|
> The PWM inputs for each L293 are pins 1 & 9, right? And the direction
> inputs are 2, 7, 10, & 15? With each pair of direction inputs using an
> inverter.
Right.
> The data sheet from National gives pin 3 as direction and pin 5 as PWM.
> Did you connect it like in the picture or is the picture wrong.
>
> I thought I would ask before a I etch my board for the 18200's.
YIKES!!! you are right, I'll have to check this tonight. It looks
like I have pins 3&5 swapped on the 18200.
--
tgb@bnr.com
|
|
Message is in Reply To:
 | | Re: Adapting the LMD18200
|
| Tom I got a couple LMD18200's from National and I'm getting ready to connect them to my HB. Looking back in my list of messages I got this: (...) This part is OK, but I'm not sure about the rest. (...) The PWM inputs for each L293 are pins 1 & 9, (...) (28 years ago, 29-Sep-96, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
