Subject:
|
servo ports on Exp board...help?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 21 Mar 2000 22:22:59 GMT
|
Viewed:
|
1221 times
|
| |
|
|
Hi
the servo ports on my expboard seem to work fine, but when the servos
are'nt active ( init_expbd_servos(0); ) and a motor is turned on the ports go
crazy , servos will turn eratically, with hacked servos they just move in one
direction. Would a filter cap help and if so were would one put it , in the
motor ports or servo supply?
Thanx -Alex
PS- now that I think about it could seperating the servo supply to a diff. batt
work?.
Thanx again.
|
|
Message has 2 Replies:
 | | Re: servo ports on Exp board...help?
|
| Hi, We saw this exact problem last year. Our servos went so crazy that they actually destroyed their gears and had to be scrapped. The fix is simple, solder a capacitor across the motor leads. The motor causes noise on the lines which the servo (...) (25 years ago, 21-Mar-00, to lugnet.robotics.handyboard)
| | | Re: servo ports on Exp board...help?
|
| Hi again, I should have mentioned this in the first message. In our case, the motor that was causing the problems was a fan motor (to blow out a candle) and it was completely electrically isolated from all of the other circuitry. It had its' own (...) (25 years ago, 21-Mar-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
