 | | Re: Non-polaroid Sonar
|
| (...) No, that's a very good question. It had me confused, too. The second argument to bit_set and bit_clear is not actually the index of a bit at all; it's a bit mask. For example, when you do bit_set( 0x1021, 3 ), the 3 becomes 0000 0011 in (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Non-polaroid Sonar
|
| Hi all, I'm now building the ultrasonic sensor from kam leang's page, did anyone interface it with handyboard?? Can anyone give me some advice on driving it? thanks Frankie Lai 97139371d@polyu.edu.hk (...) to bit_set and bit_clear is not actually (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Non-polaroid Sonar
|
| Hi Everyone! If anyone gets the interface to work, I'd love to post it on my site along with the appropriate references and credits. It would be neat if the sensor works with the HB! Good luck! (...) ______ ______ ---...--- |_ _| |_ _| Kam Leang | (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
| | | | | Getting the L297 into wave drive mode
|
| Hi I'm using the L297/L298 chip configuration to run 4-phase unipolar stepper motors. Currently I'm driving them in half-step mode but I'm not getting enough torque.. :( Has anyone successfully gotten the L297 chip into wave drive mode? I believe I (...) (25 years ago, 17-Mar-00, to lugnet.robotics.handyboard)
| |
