Subject:
|
Re: GP2D02/GP2D12 w/o expansion board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 9 Mar 2000 08:58:46 GMT
|
Viewed:
|
1066 times
|
| |
|
|
> And when using the GP2D12, it's necesary to cut the resistor pullup out of the
> circuit for the port that the sensor is plugged into, correct? Thus making the
> port useless for the typical light and reflectance sensors that would
> otherwise be easily used in that port?
Why does it make the ports useless for other sensors? If you need a
pullup-resistor,
you can still solder a 47k resistor directly to your sensor-connector
between Vcc and
Sensor in. Thus in my opinion the HB can be used more flexible without
the pullup-resistors.
Further information about connecting the GP2D12 can be found at:
http://condor.informatik.uni-oldenburg.de/stueker/GP2D12
Dirk
--
------------------------------------------------------------------------
Dirk Stueker Zietenstr. 36 26131 Oldenburg Germany
Department of Computer Science University of Oldenburg
Tel. & Fax: +49 / 441 / 5 39 35
========================================================================
Home-P: http://condor.informatik.uni-oldenburg.de/stueker
E-Mail: stueker@gmx.de (=dirk.stueker@informatik.uni-oldenburg.de)
------------------------------------------------------------------------
|
|
Message is in Reply To:
 | | GP2D02/GP2D12 w/o expansion board
|
| From (URL) : "This example assumes that port PA5 on the Handy Board was connected to the input of the GP2D02 detector and that port PA0 on the Handy Board was connected to the output of the GP2D02 detector." What do PA0 and PA5 refer to? And when (...) (25 years ago, 8-Mar-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
