Subject:
|
Re: Need help with Hamamatsu P5587
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 6 Mar 2000 02:15:22 GMT
|
Viewed:
|
909 times
|
| |
|
|
I've looked high and low for info on the P5587. - it's like the thing
doesn't exists. I even went to Hamamatsu's web sight ... nothing! The
only info I've found was a message in this newsgroup. Below is a copy
of it. I haven't hooked mine up yet so I can't vouch for its content.
When you get it working, please post what you did back to this newsgroup.
I'm very interested.
Good luck,
Rick
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
> I'm not an ASCII artist, so I'll attempt a verbal description.
> View the P5587 with the emitter/detector side facing you and
> have two pins on the left and three on the right. In this
> position pin-1 is in the upper left corner, pin-2 in the
> lower left, pin-3 in the lower right, pin-5 in the upper right.
>
> pin-1 emitter cathode, ground
> pin-2 emitter anode, 680R to +5V
> pin-3 sensor output, 6K8 pullup to +5V
> pin-4 sensor ground
> pin-5 sensor Vcc, +5V
>
> Hamamatsu recommends a cap. larger than 0.01uF from pin-5 to
> ground as near the chip as practical ... but I don't use one.
>
> hope this helps,
> - - - Nick - - -
huan nguyen wrote:
>
> Anyone know how to connect the Hamamatsu P5587 to the Handy Board(with an
> expansion) Schematic or pins-out would be great.
>
> If your sensor output port already taken, is there any other port on the
> handy board we can use to connect the Hamamatsu P5587?
>
> What test routine do we have to use?
>
> Any help would be really appriciated.
>
> Thanks,
> Michael.
|
|
Message has 1 Reply:
 | | Re: ssc servo controller
|
| hey everyone! i just got my ssc servo controller and i'm having trouble. I don't know how to connect it to the handyboard or expansion board. this is what i'm assuming, just let me know if i'm wrong, it connects with the modular jack to the PC (can (...) (25 years ago, 7-Mar-00, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | Need help with Hamamatsu P5587
|
| Anyone know how to connect the Hamamatsu P5587 to the Handy Board(with an expansion) Schematic or pins-out would be great. If your sensor output port already taken, is there any other port on the handy board we can use to connect the Hamamatsu (...) (25 years ago, 5-Mar-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
