To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 6950
    Re: Analog port shaft encoder
   Tried what you said Joshua, I went through all the analog ports and manually fed them with a TTL signal from a function generator at a relatively low frequency of 5Hz and wrote this little test code to test it. In this example, the sencdr3.icb has (...) (25 years ago, 23-Oct-99, to lugnet.robotics.handyboard)
   
        Re: Analog port shaft encoder —Gary Livick
   Rob, I use these same encoders just as you do, and they work fine. However, the spacing of the encoders from thier targets is important for proper function. 1.5 to 2 mm works well for me. In addition, I have had to play with the encoder high (...) (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR