Subject:
|
Re: Using SPI
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 23 May 1999 22:19:08 GMT
|
Original-From:
|
Joe Marie J. Maja <maja@robotics.is.tohoku.ac.ANTISPAMjp>
|
Viewed:
|
973 times
|
| |
|
|
Gary Livick wrote:
> I am using the SPI port to communicate with another Handy Board. I have
> written a routine in IC that will pass bytes between controllers just as
> it is supposed to work. However, the code is not very clean and it is
Gary,
We used the PA7(transmitting board) and PD0(receiving board) in wireless
and wired mode. This is quite easy to do. Pete Eacmen have done the wired
stuff while I did the wireless stuff.
With wired one, you can transmit @9600 baud with no problem.
I would like to try the SPI port but my transciever module can only
transmit reliably at 300 baud, so I used the Asynchronous (PD0..) stuff.
joema
|
|
Message is in Reply To:
 | | Using SPI
|
| I am using the SPI port to communicate with another Handy Board. I have written a routine in IC that will pass bytes between controllers just as it is supposed to work. However, the code is not very clean and it is very touchy. Change one thing and (...) (25 years ago, 22-May-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
