Subject:
|
Using SPI
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 22 May 1999 17:47:32 GMT
|
Original-From:
|
Gary Livick <GLIVICK@saynotospamPACBELL.NET>
|
Viewed:
|
775 times
|
| |
|
|
I am using the SPI port to communicate with another Handy Board. I have
written a routine in IC that will pass bytes between controllers just as
it is supposed to work. However, the code is not very clean and it is
very touchy. Change one thing and it may not work. Has anyone else put
together working IC code to communicate between controllers?
Thanks,
Gary Livick
ps: Hello Fred.
|
|
Message has 1 Reply:
 | | Re: Using SPI
|
| (...) Gary, We used the PA7(transmitting board) and PD0(receiving board) in wireless and wired mode. This is quite easy to do. Pete Eacmen have done the wired stuff while I did the wireless stuff. With wired one, you can transmit @9600 baud with no (...) (25 years ago, 23-May-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
