Subject:
|
Re: SHARP new product
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 10 May 1999 12:58:29 GMT
|
Original-From:
|
shsc9801@condor*StopSpammers*.stcloudstate.edu
|
Viewed:
|
2167 times
|
| |
|
|
I was looking at that this weekend. I am presently using 4 gp2d02's and am
about to order 2 more. the distance on these gp2d12's is no different and
I think one might have more control over the gp2d02 since you control the
digital output to it (correct me if I am wrong). Of course, if you do not
have that digital output available, then the gp2d12 might be better.
Scott
> Hello everyone,
>
> Sharp recently release the new GP2D12 (General Purpose Distance
> Measuring Sensors). Which performs same as the GP2D02.
>
> The new product have only 3 pins - Vo, Gnd, and 5V. Vo is an analog
> output, which means you can use it on any available analog ports of
> Handyboard. You can connect it directly to PE0 - PE7.
>
> With this, you can use the analog(int ) command to get the distance.
> Much simpler than using the GP2D02. And another thing, the supply is
> 5V.
>
> You can find the data sheet in this site:
>
> http://www.sharp.co.jp/ecg/NewProducts/NewProducts.html#gp
>
>
> joema
Scott Sherman
IT Spec. II
St. Cloud State University
720 4th Avenue South
Academic Computer Services
ECC Building, Room 101
(320) 255-4888
|
|
Message is in Reply To:
 | | SHARP new product
|
| Hello everyone, Sharp recently release the new GP2D12 (General Purpose Distance Measuring Sensors). Which performs same as the GP2D02. The new product have only 3 pins - Vo, Gnd, and 5V. Vo is an analog output, which means you can use it on any (...) (27 years ago, 9-May-99, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
