Subject:
|
charger
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 9 May 1999 19:48:56 GMT
|
Original-From:
|
FRED MARTIN <(fm2852@)saynotospam(chi.devry.edu)>
|
Viewed:
|
714 times
|
| |
| |
I have an old 'wall wart' lying around. It has a rating of (12 vdc 1 amp
output).
i was wondering if i can use it on the handy board. the specs i read about
the handy board call for a 12v 500mAmp output. any response would be
appreciated.
FRED
|
|
Message has 2 Replies: | | Re: charger
|
| (...) In short, No. The charging cicuitry on the HB (especially the zap mode) is designed for a 500ma supply. People have had problems with 1 amp ones. Best, Duncan (25 years ago, 9-May-99, to lugnet.robotics.handyboard)
| | | Re: charger
|
| (...) I'm relying on non-handyboard experience here, but I'm going to assume that's too much. One amp is a heavy load, and although there's a 5v regulator on the circuit, I'd guess that it's not rated for 1 amp (it may just run hot) and might not be (...) (25 years ago, 10-May-99, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|