Subject:
|
Re: first step in assembly of the handy board...
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 18 Apr 1999 16:33:38 GMT
|
Original-From:
|
Duncan Orthner <orthner@idirectSTOPSPAM.com>
|
Viewed:
|
1081 times
|
| |
| |
At 09:43 AM 4/18/99 -0500, Jon Ryan Schuck wrote:
> I'm kinda new at this...Can anyone tell me what voltage I should be
> checking with my multimeter(1000 or 200 or 200M etc..)? I'm on the
> first testing stage of the main assembly of the handy board and I get no
> voltage and GND and +5v spot, also my led does not light. I can't go
> any further until I solve this problem. Can someone please help me?
If you are at section 4.1.2 of the assembly manual, follow the debugging
routine outlined in 4.1.3 ie. check the DC adapter for polarity, check the
LED for polarity, check the orientation of U13 and D3...
Hope this helps, Duncan
|
|
Message is in Reply To:
| | first step in assembly of the handy board...
|
| I'm kinda new at this...Can anyone tell me what voltage I should be checking with my multimeter(1000 or 200 or 200M etc..)? I'm on the first testing stage of the main assembly of the handy board and I get no voltage and GND and +5v spot, also my led (...) (25 years ago, 18-Apr-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|