| | Re: Increasing current output to motors on HandyBoard Gary Livick
| | | Howdy, My original suggestion was to use *solid state* relays. They don't have any contacts. I use them plugged right into my Rug Warrior board at the motor output ports (would work the same on my Handy Board, but I have it on a smaller base, and (...) (25 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
| | | | | | | | Re: Increasing current output to motors on HandyBoard MAR ERICSON
| | | | | So that's like $28 for the H excluding the protecting circuitry? How much did this setup cost for both motors? ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the (...) (25 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
| | | | | | | | | | | | Re: Increasing current output to motors on HandyBoard Gary Livick
| | | | | Total cost for both, $56.00. Smaller ones are cheaper. Again, the advantage is convenience, not cost. These pulg right into the motor driver output ports on either the Handy Board or the Rug Warrior with the L293D left in place, and take no other (...) (25 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
| | | | | | |