Subject:
|
Expansion board questions
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 12 Feb 1999 23:28:12 GMT
|
Original-From:
|
Clancy Nelson <NELSON3@stopspamJCN1.COM>
|
Viewed:
|
1042 times
|
| |
|
|
I just finished my expansion board kit, it went together quite nicely
(thanks to everyone who gave me advice on its construction) but it doesn't
seat all the way down on the Handy Board because it hits the crystal which
protrudes above the the other components on the HB, is this normal or is the
crystal on my HB taller then normal?, it lack about 3/16'' of going all the
way down. Also, is there procedure for testing the expansion board?.
Thanks,
Clancy
|
|
Message has 1 Reply:
 | | Re: Expansion board questions
|
| (...) Hi Clancy, Sounds like your HB has a full height crystal. I think a half height one is in the specs, if you're worried about it switch it with a shorter version. You could also use a ceramic resonator, they're shorter than the crystal. (...) I (...) (26 years ago, 13-Feb-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
