Subject:
|
Re: BEEPER
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 7 Feb 1999 13:41:56 GMT
|
Original-From:
|
Fred G. Martin <fredm@+nomorespam+media.mit.edu>
|
Viewed:
|
792 times
|
| |
| |
it *might* be comms problems between the HB and your PC.
if you can find an old 386/486, try the downloader on that. also,
try booting your PC into DOS mode and see if things work better.
f.
In your message you said:
> Dear Friends,
> We have put ICs 6811,74374,74244,62256LP,74132,74138 on the handy
> board.The charger interfacer board is completely ready.All resistors,
> capacitors have been completely connected.LCD is not connected.
> When we try to download the pcode, it downloads perfectly well.
> However,when we boot IC it gives some errors. In a few cases,the beeper
> beeps continuously and IC does not boot. In certain cases the beeper
> beeps only once on reset and after that IC boots properly. When We
> entered 1 + 2;
> We got the answer as 3 properly. However when We do 123 * 2; We get
> different answers at different times. All answers We get are multiples of
> 123 like 123, 246 ,492.
> In a few cases the beeper does not beep at all on reset and IC
> does not boot. I believe that there is a short somewhere which is causing
> problems. Can any one please tell me where the problem can possibly be?
> Yours sincerely,
> Nitin
>
>
|
|
Message is in Reply To:
| | BEEPER
|
| Dear Friends, We have put ICs 6811,74374,74244,622...4132,74138 on the handy board.The charger interfacer board is completely ready.All resistors, capacitors have been completely connected.LCD is not connected. When we try to download the pcode, it (...) (26 years ago, 7-Feb-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|