To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5371
5370  |  5372
Subject: 
Re: A few questions...
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Fri, 5 Feb 1999 03:23:32 GMT
Original-From: 
Fred G. Martin <fredm@media.mit^antispam^.edu>
Viewed: 
1230 times
  
a few notes...

in the faq there is a discussion about how to measure the resistance
of a motor coil, as a way of determining if it's compatible with the
hb.

also in the faq, is a description of a mod that will allow using a
separate power supply for the motors.

re: motor power, while the "fd()" and "bk()" functions apply full
power, the "motor()" function allows you to modulate the power level
between 0 and 100 percent.

fred


In your message you said:
Hello all,

I have gotten both a Handy Board and an expansion board and they both appear
to work. My servo problem reported earlier is no longer an issue.

I plan to use the HB with two High Power gear box/motor sets I got from HVW
Technologies. They seem like they will work ok but I am not so sure if they
are 100% compatable with the Board. By that I mean there was no info in the
gearbox/motor kits that specified voltage or amps for the motors and don't
want to shorten the life of the Board. Does any one have any experience with
these Motor/gearbox sets (mfg. bt Tamiya)? Any tips on how to use them
safely?

Also, maybe its the ratings on the motors, but the motor function that
allows you to specify power levels appears to only turn it full on. I dont
want them running that fast. Any tips here?

Finally, I want to use the board with a full time battery backup that wont
be drained by motors, etc. Is there a way to isolate the processor battery
from the rest of the board?


Thanks for all your help out there... great job, Mr. Martin.

Bob K.





Message is in Reply To:
  A few questions...
 
Hello all, I have gotten both a Handy Board and an expansion board and they both appear to work. My servo problem reported earlier is no longer an issue. I plan to use the HB with two High Power gear box/motor sets I got from HVW Technologies. They (...) (26 years ago, 5-Feb-99, to lugnet.robotics.handyboard)

3 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR