 | | Motor outputs —Keith - Lui
|
| | | Dear all, I asked this question before but I might have used the wrong wordings. Here I try again. As you all know, the HB 's motor outputs give PVM, however, it gave me problems when I tried to amplify the power (both current and voltage.) Is there (...) (26 years ago, 2-Feb-99, to lugnet.robotics.handyboard)
|
| | | |
| | | | | Re: Motor outputs —Will Bain
|
| | | | (...) I'm not quite sure if this is what you are looking for, but if you need to run motors that are not compatible with the HB's built-in H-bridge, try one of the following: (1) If you need up to twice the current, try piggybacking more motor (...) (26 years ago, 3-Feb-99, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Motor outputs —michael lang kee
|
| | | | I was wondering if anyone out there knew where to get parts for the sonar board. I have fried the two IC chips on the board, the SN28784 and TL851. Any help would be appreciated, thanks. oooo$$$...$$$oooo oo$$$...$$$o oo$$$...$$$o o$ $$ o$ o $ oo (...) (26 years ago, 4-Feb-99, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Motor outputs —Darkman
|
| | | | Texas Instruments is the original manufacturer for those IC's (...) (26 years ago, 5-Feb-99, to lugnet.robotics.handyboard)
|
| | | | |
