To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5304
    Will the SN754410 support... —Trevor Batts
    I am trying to determine whether the SN754410 motor drivers will support two small DC motors. (without killing the IC's or motor) Or will I need to add a power amplification circuit. The motors are rated @ 6v ?A. Test show that they pull 0.35A (...) (26 years ago, 1-Feb-99, to lugnet.robotics.handyboard)
   
        Re: Will the SN754410 support... —Fred G. Martin
   if the worst-case current is 1.5A, you're probably OK -- the SN754410's have thermal protection for over-current conditions. they're rated for an amp continuous, so you're not too far out of bounds. one cause for concern is if the 1.5A measure is (...) (26 years ago, 2-Feb-99, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR