To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5039
    sensors input —Michael Toh
   hi everyone, i have tried to configure a set of sensors used for sensoring the wall in the maze. the circuitry of each of the sensors is: +5V +5V ----- ----- | | | | \ \ / / R1=82 ohm \ \ R2=120Kohms / / | | | | ------- |/ IR emitter \./ |\ IR (...) (26 years ago, 30-Dec-98, to lugnet.robotics.handyboard)
   
        Re: sensors input —K.L.McKinnon
   You don't really show your connection to your Handyboard, but I would suspect that with 16 connectted in parallel, you are probably drawing sufficient current to drop your voltage below the reset value of the micro monitor (DS1233? if I remember (...) (26 years ago, 1-Jan-99, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR