Subject:
|
Sonar question
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 3 Dec 1998 17:42:31 GMT
|
Original-From:
|
ruizvic@mx1AVOIDSPAM.ibm.com
|
Viewed:
|
2447 times
|
| |
| |
Hi to all, I would like to know
what difference there are if I connect the
6 diodes between the Handy Board & the Polaroid Sonar Card. Can I connect
the cards without diodes?
I tested the voltage at the Catode at the end of the 6th diode and my
Voltmeter showed 4.5 volts.
Should we use the 3 amp diodes?
Could somebody advise?...
Thanks in advance for your information. :-)
Victor G. Ruiz Aranda ruizvic@mx1.ibm.com
Development Software
T/L 877-7306. Ph Number 011-523-669-7306
GPL Guadalajara, Jal. Mexico.
|
|
Message has 1 Reply: | | Re: Sonar question
|
| The Polaroid Sonar board requires a supply voltage less than 7 volts. The battery of the handy board is around 12, so you'll probably shorten the life of your sonar board considerably if you connect it straight in (i.e. burn it up :.)). The diodes (...) (26 years ago, 3-Dec-98, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|