To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 484
  Question on analog(). Negative voltage
 
Last time, I learned that the values of analog() corresponds to the voltage between 0 and 5. What if the signal to the analog port is a negative voltage. For example, -2 volt ? In that case, does that mean I have to use another formula or make some (...) (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)
 
  Re: Question on analog(). Negative voltage
 
(...) DO NOT SEND NEGATIVE VOLTAGES INTO THE 6811, you will destroy the analog input circuit. Any voltage outside of the 0 to 5 v range is hazardous, unless it is current-limited to a few milliamps. (...) Are you sure about this? On page 49 of my (...) (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR