Subject:
|
Does the HB NEED 9.6 volts?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 13 May 1998 17:39:34 GMT
|
Original-From:
|
brian-c@technologist.com(spamless)
|
Viewed:
|
2110 times
|
| |
|
|
I am planning on using stepper motors with a handy board, which hopefully I will
have in a week :)
The specs on the HB say it uses 9.6 volts. Is this a required voltage? or can it
be another rating as long as it is within the regulators limits. Basically I
want to use 12 volt motors, but not at 9.6 volts. I am assuming if I use 12
volts the regulator will still supply 5 volts to the circuit, correct?
Also, does anyone know what the minimum voltage which can be supplied is?
_________________________________________________
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Brian Carvalho [ brian-c@ieee.org ]
DeVRY Institute
New Jersey
_________________________________________________
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
