Subject:
|
Re: Big adapters?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 14 Apr 1998 17:00:09 GMT
|
Original-From:
|
Fred G. Martin <fredm@#StopSpam#media.mit.edu>
|
Viewed:
|
1442 times
|
| |
|
|
In your message you said:
> Hello all, I'll just briefly restate my earlier questions for ease of
> responding:
>
> 1. Why are we encouraged not to use big adapters (>1A) for the HB? Is
> it because of the charging circuit, or does it fry the board?
because if you put it into zap mode, you'll fry your batteries --
unless you've switched to a much higher amperage pack.
>
> 2. Can I plug a big adapter into the charging board, set it to Zap mode,
> and just use it to drive my tethered robot instead of batteries?
> (i.e. remove the batteries entirely)
no, because you can't send that much current down the RJ11 cable.
unless your robot draws very little power even when motors are on;
i.e., less than 500 mA or so.
fred
>
> Cheers, Skye.
>
> +-----------------------------------------+----------------------------+
> | Skye Legon | University of Waterloo |
> | Systems Design Engineering | __/ __/ __/ __/ |
> | Pattern Analysis & Machine Intelligence | __/ __/ __/ __/ __/ |
> | 143 Columbia St. West, Unit E-4 | __/ __/ __/ ____/ __/ |
> | Waterloo Ontario CANADA N2L 3L2 | __/__/__/ __/__/\__/__/ |
> | +1(519)888-9249 | ______/ ___/ \___/ |
> | slegon@uwaterloo.ca | DC 2620, 888-4567 x5192 |
> +-----------------------------------------+----------------------------+
>
>
|
|
Message is in Reply To:
 | | Big adapters?
|
| Hello all, I'll just briefly restate my earlier questions for ease of responding: 1. Why are we encouraged not to use big adapters (>1A) for the HB? Is it because of the charging circuit, or does it fry the board? 2. Can I plug a big adapter into (...) (27 years ago, 14-Apr-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
