Subject:
|
Re: Another pcode_hb.s19 Downloading Problem
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 17 Oct 1997 23:29:32 GMT
|
Original-From:
|
Fred G. Martin <FREDM@MEDIA.MITspamcake.EDU>
|
Viewed:
|
1621 times
|
| |
|
|
if using DLM, the proper switches are:
dlm -ns -256
plus your COM port.
make sure you are running in DOS, not a DOS shell. If using Windows,
use HBDL.EXE.
Fred
In your message you said:
> I am using an HB that I bought fully assembled from Gleason Research. When
> attempting to download the pcode_hb.s19 using via
> dlm(1) a:\pcode_hb.s19 -mb -ram -256
>
> I get the following after all the dots:
>
> Synchronizing with board . . . OK
> Sending a:\pcode_hb.s19 at 9600 baud
> Serial Line echo error (wanted 57, got 3e)
>
> I tried other switches: -ns -port COM1 with the same results. I plugged
> the interface/charger board directly into the computer eliminating
> potential cable problems. All get the same result, although occasionally
> different wanted, got codes.
>
> It is something dumb, I am sure. But which dumb thing is it?
>
> John Bachman
>
>
>
>
>
>
|
|
Message is in Reply To:
 | | Another pcode_hb.s19 Downloading Problem
|
| I am using an HB that I bought fully assembled from Gleason Research. When attempting to download the pcode_hb.s19 using via dlm(1) a:\pcode_hb.s19 -mb -ram -256 I get the following after all the dots: Synchronizing with board . . . OK Sending (...) (27 years ago, 17-Oct-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
