Subject:
|
Manipulate the LCD in assembler
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 27 Aug 1997 03:28:50 GMT
|
Original-From:
|
German Gentile <GGENTILE@CVTCI.COM.ARsaynotospam>
|
Viewed:
|
1244 times
|
| |
|
|
I have write a code for manipulate the LCD in the handy board. Because i
can't use a battery backed RAM, i need to write in assembler. Well , i'm
really read all the FAQ for LCD and for Handy board (including the apendix
B for the 6270) .I'm using the rigth for the init and i can't make the LCD
clear or cursor blink... it's simply dead. Obviously, the LCD work in IC.
All i get is the black blocks!!!!!!!!!! Please help me!!!!
I send the code, anyone please take a look.
Thanks friends... ;)
German Pablo Gentile
Systems Engineer. Electronics Expert. (really??? ;>) )
ggentile@cvtci.com.ar
--
MIME ATTACHMENTS DISCARDED:
1. Content-Type: application/octet-stream; name="Prueba4.a"
Content-Description: Prueba4.a (A Archivo)
Content-Disposition: attachment; filename="Prueba4.a"
Content-Transfer-Encoding: quoted-printable
Content-Length: 9257
|
|
Message has 1 Reply:
 | | Re: Manipulate the LCD in assembler
|
| At 11:28 PM -0400 on 8/26/97, German Gentile wrote: Folks, Ok, I took a look at the code last night. I found simple errors like not initializing the stack, addressing variables in RAM chip when in single chip mode and forgetting to use # for (...) (27 years ago, 28-Aug-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
