To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 2525
2524  |  2526
Subject: 
Re: more servo
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Sun, 27 Jul 1997 22:33:09 GMT
Original-From: 
Terry P. Gathright <669@worldnet.att#antispam#.net>
Reply-To: 
669@postoffice.worldnet.=ihatespam=att.net
Viewed: 
3291 times
  
Joe Martin wrote:
> 
> After replacing my old servo.c file which with the one downloadable from
> the web site I managed to get servo.c and .icb into the board but I still
> cannot get any response from my servo.The wires are coloured brown then red
> then orange.I have been treating the orange as most likely to be the signal
> and the brown as most likely to be the earth.From my understanding the
> signal input of digital 9 sensor becomes the signal output for the
> servo.The programs I write download fine but there is never any response
> from the servo motor itself,nor does it respond when I write commands at
> the ic prompt.Does anyone know of any possible solutions?
> Thank you,
>                  Joe Martin
> Email:joema@mpx.com.au
Joe,
did you use     servo_on()  ?



Message is in Reply To:
  more servo
 
After replacing my old servo.c file which with the one downloadable from the web site I managed to get servo.c and .icb into the board but I still cannot get any response from my servo.The wires are coloured brown then red then orange.I have been (...) (29 years ago, 27-Jul-97, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR