Subject:
|
Problems with my motors
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 8 Jul 1997 18:49:14 GMT
|
Original-From:
|
Bernd Klein <bernd_klein@hotmail.IHATESPAMcom>
|
Viewed:
|
572 times
|
| |
|
|
Hi
my handyboard works fine, but i have a big problem with my motors.
If i use the "FD(x)" command my motor runs very well. If i use the
"motor (x,100)" command my motor haven4t enough power and both led
(green + red) flash. It4s a motor from a copier (12V) and have a
metal-gear. My handy-board works with 9.6V.
by the way.
I use old copier to disassemble them. There are a lot of good stuff in
this machines (Stepper-Motors, DC-Motors, a lot of gearwheels, ball
bearings etc.) Most of the motors works normaly with 20-24V DC. But i
use them with 9.6V from my handyboard an most of them works fine.
thanks for help
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
