Subject:
|
Soldering...
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 20 May 1997 13:14:46 GMT
|
Original-From:
|
Fred Cass <fcasshb@usa&AntiSpam&.net>
|
Viewed:
|
1948 times
|
| |
|
|
> Hi, I'm planning to purchase the handyboard as a kit from Digital
Mirco >System, since I'm a bit tight with money. However, I'm a bit
hesitant >about assembling the kit because I have no experience at all with
> soldering.
Just a note of encouragement... I had never built anything
like the HB before (I'm a software type guy), but thanks to Fred
Martin's concise instructions I had no problems.
What really helped me were a
few simple tips on soldering from a friend. Basically what everyone
else has already told you here. Just make the point of the low wattage
iron contact both the pad on the board, and the pin of the component.
Then basically stick the thin solder in between the two, and the solder
should wick in. If it's not working well, you may need to hold it there
for 1 or 2 seconds to ensure it's hot enough. And also make sure the tip
of the iron is always shiny clean.
After those simple tips, I was a soldering madman. And it came out
looking really nice, and works perfectly.
You'll do fine...
-=Fred
Cass=-
|
|
Message has 1 Reply:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
