To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 198
    OC2 and OC3 outputs? —Mike Ross
   Where on the v1.2 board do I tie into the OC2, OC3, and OC4 output lines? Is there a schematic which has all the I/O pins labeled? I need to use the OC lines to output pulse trains. Does the library software use these ports for the motor() commands? (...) (29 years ago, 23-Mar-96, to lugnet.robotics.handyboard)
   
        Re: OC2 and OC3 outputs? —Fred G. Martin
   Take a look at the schematics, which are linked from the top page of the Handy Board web site. The info you are looking for is in the CPU / memory schematic. For the DC Motor outputs, the board uses a separate output latch---not the timer outputs. (...) (29 years ago, 24-Mar-96, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR