Subject:
|
Servos again.
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 5 Mar 1997 10:40:47 GMT
|
Original-From:
|
JonKo <jonko@gyda.hiof.noANTISPAM>
|
Viewed:
|
1982 times
|
| |
|
|
Hi.
I'm still having problems with my servos and the board.
I got the servos connected to the port 9 and the fourth port from the
right on the handyboards expansion bus. (Think this is correct)
But when i enable ONE of the servos (Only loading the servo_a7.icb) and
init'ing it, BOTH motors starts to 'humm', and they wont respond to ANY
pulse command. Could this be a problem with the powersupply ?
I've tried to move the setup a little away from the computer to reduce
interference, but it did not seem to help...
If anyone of you have a little bit of C-code that definatly works on two
servos, and is able to send it to me, i would be grateful! :)
Yours
Jon Kolbeinsen
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
