Subject:
|
HB does not enter on bootstrap mode
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 11 Feb 1997 18:34:40 GMT
|
Original-From:
|
Jeszs Miguel Recuenco Ezquerra <jmrecu@encomix=NoSpam=.es>
|
Viewed:
|
1616 times
|
| |
| |
Hola,
I followed step 4.4 in the HB assembly manual. I hold down STOP-SW while
powering on the board, then the battery LED light for 1/3 s, but the
power light does not go OFF. I have checked that the MODA signal and the
RESET are present at the 68HC11, but there is allways a high level at
pin 21(TXD) of the 68HC11. I have clock signal on PIN 5 of 68HC11. With
the 68HC11 unplugged, I tested the PWR LED shorting the pin 6 of RP4 to
ground, and PWR LED goes off/on properly. So I think the problem is in
the 68HC11.
Is my 68HC11 damaged, or is locked in a "MODE of OPERATION" and need to
be unlocked by an special operation?
--
Jesús Recuenco
jmrecu@encomix.es
|
|
Message has 1 Reply:
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|