Subject:
|
Downloading problems
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 5 Feb 1997 22:07:11 GMT
|
Original-From:
|
Greg Starr <starr@unm.+NoMoreSpam+edu>
|
Viewed:
|
1377 times
|
| |
| |
After setting the CONFIG register, downloading the pcode never completes.
We get anywhere from 0 to about 1600 bytes transferred, then an error.
Everything has checked out to this point. Any hints?
*****************************************************************
* Greg Starr, Professor and Graduate Advisor *
* Department of Mechanical Engineering ph (505) 277-6298 *
* University of New Mexico, Albuquerque NM 87131 FAX 277-1571 *
* email- starr@unm.edu WWW- http://pliers.unm.edu/~starr/ *
*****************************************************************
|
|
Message has 1 Reply: | | Re: Downloading problems
|
| The memory circuit is probably flaky, or, you zapped a 6811 address line output. If you haven't already tried, swap the 6811 with a known good one. If that doesn't work, examine the ram chip addr, data bus, and select signals with a logic probe when (...) (28 years ago, 5-Feb-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|