| | Replacing Motor Driver 754410's Scott Mitchell Simon
|
| | Hello! I'm looking for feedback on my proposed modification of the HB. I need to drive a 2amp motor with 24 volts. I don't really trust the 754410's to handle that much power (not to mention the handyboard traces). What I'd like to do is replace (...) (28 years ago, 13-Dec-96, to lugnet.robotics.handyboard)
|
| | |
| | | | Re: Replacing Motor Driver 754410's Matt Harlan
|
| | | | (...) Scott The 18200's are a pretty staight forward upgrade. I'm currently using two of them to run a couple power widow motors from a 12V gel cell. They work great. They get hot pretty quick, so a heat sink is a definite must. Scan through the (...) (28 years ago, 13-Dec-96, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Replacing Motor Driver 754410's Tom G. Brusehaver/Consultant Euler Solutions
|
| | | | (...) I concur here, I have a 6inch X 6inch piece of aluminium for 2 of them, and this seems to dissapate all the heat I am generating. I could see longer runs or steeper grades would require a larger heatsink. (...) I was the one who originally (...) (28 years ago, 13-Dec-96, to lugnet.robotics.handyboard)
|
| | | | |