Subject:
|
Re: frame material
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 4 Dec 1996 19:30:39 GMT
|
Original-From:
|
ED Spike <SPIKE@EESTAFF.watstar.uwaterloo.ca%nospam%>
|
Viewed:
|
2248 times
|
| |
|
|
On Wed, 4 Dec 1996, Scott Sherman wrote:
Hi,
> Does anyone know of a good place to get material for building a frame for
> a robot - preferably aluminum? This is for a robot who's overall size is
> app. 12 inches by 12 inches so it needs to be something like 3/4 inch
> channel with some thickness to it (but it has to be light too, of course).
> thanks, > > Scott > sherman@plains.nodak.edu > >
Suggestion:
Printer Circuit board with a thickness suitable. Say 1/8 inch.
PVC plastic PC Board card guides for edging and bumper.
One can solder to the copper.
Two sided also acts as a power buss for the motor(s).
Can make layers for RFI protection.
---------------------------------------------------------------------
Ed Spike,
---------------------------------------------------------------------
|
|
Message is in Reply To:
 | | frame material
|
| Hi, Does anyone know of a good place to get material for building a frame for a robot - preferably aluminum? This is for a robot who's overall size is app. 12 inches by 12 inches so it needs to be something like 3/4 inch channel with some thickness (...) (28 years ago, 4-Dec-96, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
