| | Re: Need help with bumpers connected to the HB
|
|
Hello, Can you describe more about "HB turns itself off ?" Does the HB reset itself? The analog inputs for HB have pull-up resistors. This pull-up resistor may cause the problem. Thanks. Patrick Hui (URL) Original Message ----- From: "Haberlag" (...) (23 years ago, 23-May-01, to lugnet.robotics.handyboard)
|
|
| | Outputs
|
|
Right now I've got one Sharp GP2D05 IR Ranger rigged to TO3 and another to digital in 9. Those are working fine, but I'd like to add a servo motor, which needs one of those two ports for a signal. The FAQ mentions using the J6 SPI pins, might I be (...) (23 years ago, 23-May-01, to lugnet.robotics.handyboard)
|
|
| | Need help with bumpers connected to the HB
|
|
Hi, Ive got a problem in getting started with the Handy Board. Id like to connect a bumper detection circuit to the analog0 of my HB. But when I connect the bumper circuit to my HB , the HB turns itself off. Can anybody help me? Any help would be (...) (23 years ago, 23-May-01, to lugnet.robotics.handyboard)
|
|
| | Re: Will not keep P-Code.....
|
|
Rmoving every chips except 62256 RAM and 74HC132, and try it again if it works. Besides the memory chip (62256), please also check the 74HC373 (under-neath the 62256 RAM). Patrick Hui (URL) Original Message ----- From: "Kurt Telep" <kt25@drexel.edu> (...) (23 years ago, 22-May-01, to lugnet.robotics.handyboard)
|
|
| | Will not keep P-Code.....
|
|
Well, I recently got a hold of a handyboard from a |friend of mine who swore it was "junk and didnt' work" | After cleaning up some ugly looking solder joints on |the board, it powered right up and began to work |great. Well, when I went to screw it (...) (23 years ago, 22-May-01, to lugnet.robotics.handyboard)
|