|
|
 | | Check out this site!
|
| Terry Gathright came across this great site and thought you might want to check it out. We hope you enjoy it! (URL) Gathright wrote: Hi Guys, Check this location for some hi power motor drivers, I have ordered two of the 35 amp boards and will let (...) (24 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
| | | | | Re: downloading pcode
|
| Make sure that your phone wire between the HB and interface board has four wires, most generic phone wires only have two wires in them. -Dan (...) and (...) MAX232 (...) I (...) any (...) (24 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
| | | | | Re: Underwater Sensors
|
| James, maybe a moisture sensor out of a VCR could be modified to meet your needs??? They are made to detect condensation in VCR's. but if all else fails... water is a conductor, so you could theoreticly just put two bare contacts on the outer part (...) (24 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
| | | | | Re: Short Circute Problem -- EMERGENCY
|
| Raju, I have a handyboard version 1.21, on this board the battery led is working properly when it lights at power on and then goes off. According to the manual it should only remain lit when the power is too low indicating a dead battery. So I (...) (24 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
| | | | | Re: downloading pcode
|
| Brian, I had the same problem with a board I built. It turned out to be the memory was bad. I would check all the solder connections to the memory socket and make sure that it is seated properly. -DAN (...) (24 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
|
|
