 | | IC problem
|
|
I have written a small program for the Handyboard to test program flow in IC. It is supposed to print "Step1", "Step2", Step3" in sucession to the LCD in an endless loop until I reset the board. It works properly through 12 cycles but on the 13th (...) (26 years ago, 4-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Short Circute Problem -- EMERGENCY
|
|
Hi guys , i tried all the tests mentioned in the HB assembly to find out which part of the HB blown. No luck. i am giving the results here: 1) Tested the interface and charger board - looks good. (Both power supply and the MAX232 circuit) 2) Tested (...) (26 years ago, 2-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | RE: 68HC11 (Evaluation Board)
|
|
I was wondering if anyone was aware of any pre-existing library calls that would allow an individual using an Evaluation Board (EVB-68HC11)+ Buffallo Monitor(ImageCraft C v5.0) to access the system clock. I've noticed that with using Interactive C (...) (26 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | unsuscribe
|
|
How do i unsuscribe from the list? Thank you. (26 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Short Circute Problem -- EMERGENCY
|
|
Hi Rainer, thanks for your advise on this. i will fallow the test cycles mentioned in HB manual. What i noticed is , charging circuit(changeing/interface board) working and HB is working in bootstrap mode also. it is able to sync with IC in (...) (26 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
