 | | Linux and v1.21 handyboard (fwd)
|
|
Hi, I've successfully located and compiled the IC files for the Handy Board. I can load and run programs on the board, BUT the digital input(s) are not being "seen". E.g. a simple program like: void test3(){ while (1){ if (digital(10)) printf("10 is (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | communication via serial port
|
|
Hi, This isn't an off topic question... Has anyone tried programming the serial port (on Linux) to communicate with the Handyboard? I am working on an RF link between the Handyboard and a PC via serial communication, but I don't know much about (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | Re: external power
|
|
I am by no means an expert on the subject but this is how I did it. First I cut the heavy motor power trace as shown in the FAQ. Next I soldered a four pin female header on top of the expansion board where the expansion board picks up power for the (...) (26 years ago, 4-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Multiple GP2D02 range sensors
|
|
Greetings, (...) From what I could understand from the documentation ((URL) you could use one timing signal for all of them, as long as each sensor is connected to its own output line (to which the sensor would serially output its 8 bit value). (...) (26 years ago, 4-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | external power
|
|
i was wondering if i can modify the handyboard to accept a secondary power supply for the motors and still use the expansion board at the same time. if there is anything else i need to know or do, i would greatly appreciate hearing about it. thank (...) (26 years ago, 4-Oct-00, to lugnet.robotics.handyboard)
|
