| |
i was wondering if i can modify the handyboard to accept a secondary
power supply for the motors and still use the expansion board at the same
time. if there is anything else i need to know or do, i would greatly
appreciate hearing about it. thank you.
|
|
Message has 1 Reply:
 | | Re: external power
|
| I am by no means an expert on the subject but this is how I did it. First I cut the heavy motor power trace as shown in the FAQ. Next I soldered a four pin female header on top of the expansion board where the expansion board picks up power for the (...) (24 years ago, 4-Oct-00, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
