 | | IR Reception
|
|
I posted this question previously but got no reply so I am trying again. I have mounted the IS1U60 infrared demodulator on to the HB but I have realised that it can only recieve from a particular direction. Is it possible to mount another IS1U60 by (...) (26 years ago, 11-Sep-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Encoders
|
|
IC can't sample the A/D converters that quickly. As long as you're generating a nice squarewave you could connect it to one of the input capture pins and write a custom interrupt routine to maintain the count. --Chuck (...) (26 years ago, 10-Sep-00, to lugnet.robotics.handyboard)
|
| |
| | Encoders
|
|
Since some are on the subject of encoders, I have a problem I would like to get help on. I have a hall effect sensor dutifully counting pulses on a gear. The gear will rotate from 800-4000 RPM. I am running the signal through a 741 OP Amp to (...) (26 years ago, 10-Sep-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Encoders, what are you using?
|
|
Jerry, go to: EE 401 - Electrical Engineering Design Course - 1999/2000 then to shaft encoders they have 16, 32, or 64 sections you can print out. bye, Terry G. ----- Original Message ----- From: "Jerry Normandin" <jerrynormandin@ne.m...iaone.net> (...) (26 years ago, 10-Sep-00, to lugnet.robotics.handyboard)
|
| |
| | I fixed my slop!
|
|
Hey.. I added a quick reverse drive to the moter.. it turns out my slop was the drive system coasting! I added brake and I am more accurate now!!!!!!! (26 years ago, 10-Sep-00, to lugnet.robotics.handyboard)
|
