|
|
 | | Re: Connect HP 48GX
|
| Gruezi/ Hi, (...) Instead of using the serial port, how about using the HP4**x IR port? I recall there being HP4**x programs that emulate IR remote controls which should be easy to modify (?) for general-purpose communications. Marco A. Assfalk de (...) (24 years ago, 6-Jul-00, to lugnet.robotics.handyboard)
| | | | | Handyboard startup problems
|
| Hi all, I'm having some problems with me previously functioning handyboard. I'm using a standard board which has worked fine for nearly a year. Recently it didn't get any use for awhile and the batteries ran down. After charging them for 18+ hours I (...) (24 years ago, 5-Jul-00, to lugnet.robotics.handyboard)
| | | | | Re: 6.8nF Capacitor
|
| (...) Not knowing what parts the HB uses, but assuming it is something like a polystyrene cap, then I think I have some in my component drawer. Send me your address, and I'll stick a couple in the post. Best Wishes (24 years ago, 5-Jul-00, to lugnet.robotics.handyboard)
| | | | | Re: VECTOR 2X
|
| This is my routine to use the Vector 2x with my board (see link below my name) with an I/O expansion board connected. You will need to change the I/O port #defines to work with the Handy Board I/O ports on your expansion board, but other than that (...) (24 years ago, 4-Jul-00, to lugnet.robotics.handyboard)
| | | | | Re: VECTOR 2X
|
| Hi Robert, It has been over a year since I have had the vector 2x connected to my board but if you follow the instructions that Tom Brusehaver posted in contributed software everything should work ok. You will have to connect to one of the motor (...) (24 years ago, 4-Jul-00, to lugnet.robotics.handyboard)
|
|
