 | | Test **
|
|
Just checking something... (24 years ago, 29-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: hbdl question
|
|
Todd, There are Two options on the Windows program HBDL.EXE 1. Download - This downloads a bootloader then a file to the external RAM of the handy board. 2. Burn - This (attempts) to download a file to the HandyBoards 68Hc11 internal EEPROM. Thus (...) (24 years ago, 28-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: my handy is death ????
|
|
Do you mean that when you turn on the Handy Board, the motors start to run spontaneously? I used to have that problem, too, but only when there was no program yet loaded. I saw a message on this mailing list a few months back that suggested a remedy (...) (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: IC question
|
|
You might try something like: while( 1 ) { if( start_button() ) printf( "you pressed the start button\n" ); else printf( "\n" ); msleep( 250L ); } or simply: { start_press(); printf( "you pressed the start button\n" ); } -- Will (...) +---...---+ | (...) (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | my handy is death ????
|
|
Mister They in my university bought 6 HandyBoard for the development of courses relations with IA. 2 of the Handyboard failed one of them sample in their screen for causes that not yet are known, the Interactive C, as if I you work correctly, the (...) (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | hbdl question
|
|
when using hbdl what does the burn the board option do? It says download to eprom. What file should you download to the eprom? Is this necessary? Thanks, Todd (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | IC question
|
|
Just got my handyboard, and I am new to programming, so I have a probably simple question for you all. I have been playing around with IC trying to get responses on the LCD from start button presses. if I send the following on the IC command line : (...) (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Digital outputs.
|
|
You can use solid state relays with 5 VDC inputs and DC outputs to control large loads. The inputs require very little current. It is less expensive to build transistor switches, which will do the same thing, but obviously much simpler to use (...) (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | handy board, motor problems
|
|
I have six handy board for academics activities in my University. In two, I have problems: When move power switch ON, the same indicators(leds) of motors outputs work, with load programs and without load programs. ¿What's happening? Thank (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | CCD on the handyboard ??
|
|
Maybe someone already discussed this argument.... I'd like to connect a CCD to the handyboard, but how ?? What comes out from a CCD ? How to interface the CCD's output signal ? Anyone can help me ? Stefano (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
