 | | Re: Output to file option for IC?
|
|
(...) Here's a stupid idea, but might be the simplest: Run a dumb terminal program. I keep a very old version of Telix for DOS around for this purpose. Most of the dumb terminal programs have some option or other for logging or capturing to a file. (...) (24 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Motor Drivers
|
|
(...) As others have said, the system should be able to drive this. However there are some obvious 'thoughts': 1) A light that draws 300mA when running, will _momentarily_ draw a much higher value when the bulb is cold. The actual ratio between the (...) (24 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Output to file option for IC?
|
|
We have a system that was designed to let you run IC-like code on a host as if it were running on the HB. We use the HB as an extension to a larger mobile robot (the HB turns on lights, motors, etc. Our robot served candy via voice command at last (...) (24 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Output to file option for IC?
|
|
It would be cool if IC can output results to a file. well, since it can't does anyone have code available for borland c++ which will receive data over the serial port? I found some code from earlier posts, but can't seem to find one that works. I (...) (24 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Motor Drivers
|
|
300 mA shouldn't be a problem. are your main batteries low? alternately, are you sure it's 300 mA at 9v? can you measure it somehow. fred In your message you said: (...) (24 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
