 | | Motor Drivers
|
|
I am trying to run a light with the motor outputs on the handy board. I looked up the spec on the L293D and it claims to be capable of 600mA constant and 1.2A peak. The miniature light I am using draws about 300mA. When the light comes on the handy (...) (24 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: sonar mapping with evidence grid
|
|
(...) home (...) I have read that it is not actually a solid cone angle, but a peak central lobe and a few side lobes. I think the best way to figure this out is to mount your sonar sensor on a rotatable head and go out to an open field. Place a (...) (24 years ago, 5-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: LED's
|
|
[Derek Healy] spake unto the ether: (...) This is just an idea skeleton, but not too hard to flesh out, if you've worked with TTL. The Handy Board memory map maps some upper 32K addresses to I/O "ports". Look at the schematic and you can see which (...) (24 years ago, 5-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | LED's
|
|
Hi, could anyone tell me how I might light LED's in sequence so that they would simulate a rev counter of an automobile & to also simulate the speed counter. I need to know how I might wire them up and how I might be able to program them using time (...) (24 years ago, 5-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Losing HB memeory
|
|
Hi all, i am having some trouble with the HB memory. i have some calioberated values stored as persistent globals. after running the program few times the HB tends to lose the stored values. What could be the problem? Many thanks Fazal (24 years ago, 5-Apr-00, to lugnet.robotics.handyboard)
|
