 | | Re: Overcharged battery?
|
|
actually this is to be expected. with no load, the diodes produce no drop. if you're worried, try hooking a DC motor (or other real load -- light bulb, 10 ohm resistor, etc). across the servo motor supply and then measure the voltage. you should see (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Overcharged battery?
|
|
I've got a pre-assembled Gleason Research HB with expansion board, and have a couple questions. We've left it plugged in (on normal charge mode) for a week or so. I started to look at the specs to hook up a Futaba servo (6V), and found that with no (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Non-polaroid Sonar
|
|
Greetings all, I've just finished building Kam Leang's sonar circuit as published on his web site, and it all seems to be working well. I am having a problem interfacing it to the handyboard however. I'm not entirely sure how to set bits high and (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Another assembly question
|
|
the fact that the two LEDs come on and then go off suggests that you *are* successfully putting the hc11 into download mode. it also happens that the hc11 TxD pin is in what's called "wired OR mode" during bootstrap. this means that it can only (...) (25 years ago, 14-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Another assembly question
|
|
I'm also at the point of trying to download to my partially assembled board for the first time. I'm able to put the board in to download mode (both led's come on for a short period of time then go off). When I start downloading the green led on the (...) (25 years ago, 14-Mar-00, to lugnet.robotics.handyboard)
|
