 | | Re: HandyBoard Assembly
|
| Eric, The pcode does load, or otherwise the beeper would not beep with the board reset. But you cannot communicate with your PC, which seems to be a very common problem with the newer and faster PC's. If you are using the freeware version of IC, try (...) (27 years ago, 9-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: GP2D02/GP2D12 w/o expansion board
|
| When using the GP2D02, you are using port A, pin 5 and port A, pin 0. That's where the PA0 and PA5 terminology comes from. I wrote that particular piece on the Acroname website, so I apologize for not being more clear. And yes, it is necessary to (...) (27 years ago, 9-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: sound generators
|
| Of course, the Handy Board has a piezo speaker built in. With the beeper and tone functions provided by IC, you can make all sorts of sound effects. You can make your robot sound like R2-D2 if you like. Also, Radio Shack sells piezo speakers. -- (...) (27 years ago, 9-Mar-00, to lugnet.robotics.handyboard)
| | | | | RE: sound generators
|
| The Handyboard has one on it. Therfore, if you look in the manual's part's list, it should list where it's from. (...) This message is for the named person's use only. It may contain confidential, proprietary or legally privileged information. No (...) (27 years ago, 9-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: HandyBoard Assembly
|
| it seems like the HB is not able to talk back to your PC. make sure the TxD signal starting from the 'hc11 is leaving the HB properly at the RJ11, reaching the interface bd, and then being cvt'ed to -10v to +10v levels out the interface bd on its (...) (27 years ago, 9-Mar-00, to lugnet.robotics.handyboard)
|
|
