 | | HB memory capacity
|
| Hi all, A funny thing happened. i tried to download a file. IC gave the message it was downloading, but just when it finishes it gives me an error saying "lost synch with board". then i unloaded some files and redownloaded the file again. this time (...) (27 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: KIPR Kit
|
| Joe, As it turned out, the edge of the pulley was right next to and perpendicular to a long beam piece. We just used hot glue to glue it to the beam and held it in place until the glue dried and had no trouble at all. The pulley can't come out of (...) (27 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: KIPR Kit
|
| (...) These are what I also have been trying to use to break the beam, they seem to be the best choice. My question was more about how you mounted the sensor. I'm curious to know what piece people had glued the sensor to, and to see if they used (...) (27 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: Servo controllers
|
| (...) If you can burn PIC processors yourself, try my page at (URL) and bonk on the serial servo controller project. I have PIC12C508 code there that allows you to control 4 servos with a single 2400 baud connection. The code is set to allow a (...) (27 years ago, 28-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: Servo controllers
|
| Yes, there is a way. Check out the serial servo controllers at (URL) one of these that you use controls up to 8 servos, and you can chain a bunch of them together and go servo nuts. -- Will Bain P.S. -- I haven't yet tried these myself. I'm curious (...) (27 years ago, 27-Feb-00, to lugnet.robotics.handyboard)
|
|
